Method of Concentration Ratio of Different Polyaluminum Chloride
If polyaluminum chloride is used improperly, the total consumption will increase, including regulating condensationpHvalues of sulfuric acid consumption and soda lime consumption. The use method of polyaluminum chloride has a lot to do with the nature of the product, that is to say, it should be adjusted on site according to different water quality. Only in this way can better results be obtained. BelowPolyaluminum chloride manufacturersThe correct usage of polyaluminium chloride will be specifically discussed.
Polyaluminum chloride is a highly efficient water treatment flocculant, usually solid particles or solid powder, so it needs to be diluted and dissolved before use. According to a certain concentration ratio, the great treatment effect of polyaluminum chloride can be exerted.Polyaluminum chloride manufacturersAccording to many years of production experience and customer feedback, summed up the following points on the concentration of polyaluminium chloride ratio method.
The use method and concentration ratio of yellow polyaluminum chloride:
Before use, the beaker test should be carried out according to the water quality to select the best dosage.Polyaluminum chloride manufacturersIt is recommended that solid products must be dissolved and diluted before being placed in water. The dilution ratio is usually2%5% (diluted according to the alumina content), the amount of dilution depends on the water quality. After complete stirring and dissolution, add according to the excellent dose determined by the beaker coagulation test. Liquid products can be placed directly or after dilution. The dilution ratio of the liquid product is2%5% (diluted according to alumina content).
The use of white polyaluminium chloride and concentration ratio:
Such products provided by polyaluminium chloride manufacturers are mainly used for paper sizing. The solid product is formulated with a content10% of the liquid. Will1.5-3.0% of the liquid was added to the slurry for sizing and stirred to mix well with the slurry.
Spray polyaluminum chloride use method and concentration ratio:
Polyaluminum chloride manufacturersRemind the solid product to press1：3Add water to dissolve into liquid, then add10-30Times water diluted to the required concentration after use. The dosage can be determined according to the different turbidity of raw water, and the better dosage can be determined. Generally, the turbidity of raw water is100-500mg/LAt that time, the dosage per thousand tons was10-20kg.
More information
